Continuous error plot (Plotly) some issues

I make experience of some issuses with the node “Continuous error plot (Plotly)”.

• First of all it doesn’t seem to work with CSS editor.

• Second I build up the following workflow where through the “Value Selection Widget” I refresh an analysis and the relative plots according to the alloy type selection

see below an example of components output.

the two plot generated by the component are substantially the same, the first is the output of the Line Plot the second one is the output of Continuous error Plot (Plotly). The problem is that when I select a new alloy (see below: “ottone 70”) the Line Plot is correctly updated but the Continuous error Plot (Plotly) it is not! To update this last plot I have to open the component and reset the node “Continuous Error Plot”. Why does it happen?

Thanks in advance for any suggestions!

Regards